How To Check A Washing Machine Commence Capacitor

1

Unplug the washing machine and get rid of the rear panel to access the motorHow to Check a Washing Machine Start Capacitor. Take away the metal cover from the begin capacitor. It's the larger of the two capacitors on the motor.

2

Draw a diagram of how the motor wires connect for the capacitor terminals and disconnect the wires from the terminals with insulated needle nose pliersHow to Check a Washing Machine Start off Capacitor.

3

Discharge the run capacitor by attaching a single alligator clip with the jumper wire towards the metal shaft from the screwdriver plus the other alligator clip for the housing in the capacitor. Touch the blade from the screwdriver to 1 set of terminals and the shaft from the screwdriver to the other set of terminals to brief out the capacitor. This can bleed the charge from the capacitor and make it protected to deal with with no the danger of a shock.

4

Set the multi-meter towards the OHM scale and touch the two lead points together. Move Washing Machine Guide the adjusting wheel until the needle is at "zero." The needle should really point straight up inside the center of the dial.

5

Touch the capacitor terminals together with the leads, red lead on left and black lead Clear Away Washing Machine Smells on suitable. The needle must move away from "zero" and point slightly toward the best side, then go back to "zero." Reverse leads and also the needle should certainly move away from "zero" even additional after which go back to "zero."

6

Replace the commence capacitor when the needle doesn't move. It suggests the capacitor is bad. If the test shows the capacitor is great, look for a further difficulty.

How To Check A Washing Machine Commence Capacitor